Select Tool

The select tool is activated either by selecting the Select Tool item of the Edit Menu or by clicking the select tool button in the Tool Bar of the Edit Mode Network Window. In Run Mode, the select tool is always active. Figure 1 shows the select tool button.


Figure 1: The select tool button from the Edit Mode Tool Bar.

The select tool allows you to select one or more nodes in the Network Pane. You select a single node by clicking it or dragging a rectangle around it when the select tool is active. You can select a series of nodes by dragging a rectangle around the nodes you want selected. You can also add more nodes to the currently selected series of nodes by holding down the SHIFT key while selecting more nodes.